Default Settings for Online Diagnostics
OBFL
PortLoopback
RewriteEngineLoopback
IntPortLoopback
BootupPortLoopback
Default Settings for Online Diagnostics
The following table lists the default settings for online diagnostic parameters.
Parameters
Bootup diagnostics level
Nondisruptive tests
Configuring Online Diagnostics
Note
Be aware that the Cisco NX-OS commands for this feature may differ from those commands used in Cisco
IOS.
Setting the Bootup Diagnostic Level
You can configure the bootup diagnostics to run the complete set of tests or you can bypass all bootup diagnostic
tests for a faster module bootup time.
We recommend that you set the bootup online diagnostics level to complete. We do not recommend
Note
bypassing the bootup online diagnostics.
Before You Begin
Make sure that you are in the correct VDC. To change the VDC, use the switchto vdc command.
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
230
Configuring Online Diagnostics
Bootup test only
Health Monitoring/On Demand when port admin
down only
Health Monitoring/On Demand
Health Monitoring/On Demand
Bootup test only
Default
complete
active