Display G And Auxiliary Functions; Selected G Functions - Siemens SINUMERIK 840D sl Operating Manual

3.9

Display G and auxiliary functions

3.9.1

Selected G functions

16 selected G groups are displayed in the "G function" window.
Within a G group, the G function currently active in the control is displayed.
Some G codes (e.g. G17, G18, G19) are immediately active after switching the machine
control on.
Which G codes are always active depends on the settings.
G Groups Displayed by Default
Group
G group 1
G group 2
G group 3
G group 6
G group 7
G group 8
G group 9
G group 10
G group 13
G group 14
G group 15
G group 16
G group 21
G group 22
G group 29
G group 30
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
Description
Modally active motion commands (e.g. G0, G1, G2, G3)
Non-modally active motion commands, dwell time (e.g. G4, G74, G75)
Programmable offsets, working area limitations and pole programming (e.g.
TRANS, ROT, G25, G110)
Level selection (e.g. G17, G18)
Tool radius compensation (e.g. G40, G42)
Settable zero offsets (e.g. G54, G57, G500)
Offset suppression (e.g. SUPA, G53)
Exact stop - continuous-path mode (e.g. G60, G641)
Workpiece dimensioning inches/metric (e.g. G70, G700)
Workpiece dimensioning absolute/incremental (G90)
Feedrate type (e.g. G93, G961, G972)
Feedrate override on inside and outside curvature (e.g. CFC)
Acceleration profile (e.g. SOFT, DRIVE)
Tool offset types (e.g. CUT2D, CUT2DF)
Radius/diameter programming (e.g. DIAMOF, DIAMCYCOF)
Compressor ON/OFF (e.g. COMPOF)
Machine the workpiece
3.9 Display G and auxiliary functions
77