Port Hybrid Pvid - HP 830 Command Reference Manual

[Sysname-WLAN-ESS1] port access vlan 3
# Assign Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port access vlan 3

port hybrid pvid

Use port hybrid pvid to configure the PVID of a hybrid port.
Use undo port hybrid pvid to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
WLAN-ESS interface view, Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the PVID setting on the port.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to permit the packets from the
PVID to pass through.
The configuration made in Ethernet or WLAN-ESS interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the
•
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
•
moves to the next member port.
Examples
# Configure VLAN 100 as the PVID of the hybrid port WLAN-ESS 1.
<Sysname> system-view
47