Mbc, Battery Charger - Motorola AT Commands G24-L Developer's Manual

Hardware Information
OK

+MBC, Battery Charger

This command allows the battery charger to be managed (start, stop or automatic manage) and get
indication for the battery level (solicited or unsolicited reports).
The Battery is external to the G24-L and connected via the 70 pin connector.
The values of the battery are: 3.2V-4.2V divided to 5 battery levels.
Notes:
Command
Type
Set
Read
Test
3-130
• When the battery level is below the minimum, the G24-L will not power up untill the
pre-chargelevel reaches the minimum level for activation.
• The G24-L will manage the charging process and algorithm when charging is enabled.
• The unsolicited reports will appear in the following cases (in case <Ind=1>):
1. Each time the level of the battery changes.
2. Inside the limits (3.2 and 4.2).
3. Charger connected/disconnected.
• The unsolicited report will appear even if the charger cable is not connected (only in
case of <Ind=1>).
• ERRORS: Trying to start a charging process without a battery, error message of: NO
BATTERY DETECTION will be received, for any other problems the following will
be received: ERROR IN CHARGING PROCESS.
Syntax
AT+MBC=<Mode>,<
Ind >
AT+MBC?
AT+MBC=?
G24-L AT Commands Reference Manual
Response/Action
OK The Set command sets the different
mode (start, stop or automatic) and
or:
sets the report to be solicited or
+CME ERROR: <err>
unsolicited.
+MBC: The Read command returns the current
status, battery level, mode and
<Status>,<Batterylevel
indication.
>,<Mode>,<Ind>
OK
+MBC: (List of The Test command returns the list of
supported modes and indications.
supported Mode),(List
of supported
Indication)
OK
Remarks
April 15, 2008