Safety And Regulatory Information; Fcc Part 15 Compliance Statement; Canadian Emi Compliance Statement; Fcc Warning - Hitachi VisionPlate 60 User Manual

1-2 Safety and Regulatory Information

• FCC Part 15 Compliance Statement

NOTE: This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
If FCC label is not present, the unit is not approved.
This equipment generates, uses, and can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that the interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
determined by turning the equipment off and on, the U
interference by one or more of the followin
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet different from that to which th
- Consult your dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the party responsible for compliance
could void the User's authority to operate the equipment. If FCC label is not present, the unit is
not approved.
NOTE: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must
undesired operation.
IMPORTANT: This product requires the use of shield
The use of non-shielded interfaced cables is prohibited.
•

Canadian EMI Compliance Statement

"This Class B digital app
Equipment Regulations."
"Cet appareil numeriqu
brouilleur du Canada."
•

FCC Warning

WARNING-FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the User's authority to operate
this equipment.
Properly shielded and grounded cables and connectors must be use
computer and/or peripherals in order to meet FCC emission limits.
This transmitter must not be co-located with any other transmitters or antennas.
g measures:
accept any interference received, including interference that may cause
aratus meets all requirements of the Canadian Interference-Causing
e de la class B respecte toutes les exigences du Reglement sur le materiel
12
ser is encouraged to try to correct the
e receiver is connected.
ed cables and connectors.
d for connection to boot
be