Installing The Battery; Removing The Battery - Motorola HDT 600 Owner's Manual

Installing the Battery

The battery is shipped from the factory uncharged and not installed.
Charge the battery before using the HDT 600 for the first time.
1. Before installing the battery, release the terminal hand strap, as
shown below.
2. Verify that the battery lock is in Unlock position.
3. To install the battery, position the battery in the right-hand side
of the battery compartment and lower it downward to its place.
4. Use a coin to lock the battery by turning the battery lock clock-
wise to the Lock position. Note that the battery is locked only
when the two dots align (See figure below).
Power Button
Battery Lock
Unlock

Removing the Battery

Important Note:
ies without losing information stored in its memory. To avoid los-
ing information stored in the memory, charged battery must be
installed within 2 minutes after removing empty battery.
6
Hand Strap
Lock
The HDT 600 enables you to replace batter-