Initial Installation Of Trunk Pcbs2 - NEC Aspila EX Hardware Manual

CÔNG TY VIỄN THÔNG VIỆT PRO
Initial Installation of Trunk PCBs
When first installing the system:
1.
2.
3.
Aspila EX Hardware Manual
Chuyên phân phối tổng đài NEC
Section 2: PCB Installation and Startup
Set the run/block switch DOWN on all COIU-LS1, COIU-LG1, 4TLIU, DIOPU, 1PRIU or
BRIU PCBs.
Insert all PCBs in sequential order. The installer must install trunk PCBs in order (i.e.; slot 5
first, slot 6 next, slot 7 next, etc.) for a sequential numbering plan.
Installing COIU-LS1/LG1, 4TLIU, DIOPU, or BRI PCB's:
The order in which trunk PCBs are physically inserted determines the num-
bering plan. For example, if four PCBs are installed in the following order,
the numbering plan below would apply:
Order of
Install
1
2
3
4
Installing PRI PCBs
The PRI Interface PCB uses the first block of 32 consecutive trunks.
For example, if you have an 8COIU PCB installed for trunks 1-8, the PRI
PCB will automatically use trunks 9-40. If you have 8COU PCBs installed
for trunks 1-8 and 17-24, the PRI PCB will use trunks 25-56. The PRI PCB
cannot use trunks 9-16 (even if available) since they are not part of a consec-
utive block of 32 trunks.
Set the run/block switch UP on each PCB.
PCB Slot # PCB
4 8COIU
5 4COUI
7 4TLIU
6 4TLIU
Section 2: PCB Installation and Startup
http://vietpro.com.vn
Line Circuits
1-8
9-12
13-16
17-20
2-49
2