5 Replacing Components of the BBU3900
Context
l
l
Procedure
Step 1 Instruct the M2000 administrator to perform the following operations for the replacement of the
WBBP:
1.
2.
Step 2 Wear an ESD wrist strap or a pair of ESD gloves.
Take proper ESD protection measures, for example, wear an ESD wrist strap or a pair of ESD
gloves, to prevent electrostatic damage to the boards, modules, or electronic components.
Step 3 Record all the cable connections on the panel of the board to be replaced.
Step 4 Disconnect the CPRI cable from the WBBP, as shown in
Figure 5-18 Disconnecting the cable
Step 5 Loosen the two M3 screws on the panel, and then remove the WBBP, as shown in
5-19.
5-16
Figure 5-17
shows the position of the WBBP in the BBU.
Figure 5-17 Position of the WBBP
TX
RX
TX
RX TX
RX
WBBP
CPRI0/EIH0
CPRI1/EIH1
CPRI2/EIH2
WBBP
The WBBP is hot-swappable.
Back up the service data or transfer the service carried by the board to be replaced if
required.
Run the BLK BRD command to block the WBBP.
WARNING
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RUN
ALM
ACT
Hardware Maintenance Guide
Figure
5-18.
Issue 03 (2010-06-05)
BBU3900
Figure