Toshiba MML-AP0124H2UL Service Manual page 73

9-2. Floor Console Recessed Type
WARNING
Be sure to turn off the power supply and the breaker
and then start a work.
No. Spare parts
Electric parts 1. Detachment
assembly (1) Remove the side cover.
(2) Remove conduit fixing plate.
(3) Remove the side plate (Front).
(4) Remove the side plate (Upper)
(5) Remove the dashboard of lead.
(6) Remove the lead cover.
(7) Remove connecting connectors (TC1, TC2, TCJ,
* Remove the connectors by unlocking the locks of the
housing part.
(8) Take off the fixing screws of the electric parts
2. Attachment
Following to the works in 1 of
the parts as original in the reverse procedure.
* Attach the lead cover by inserting the pawls of the
piping covers into the square holes of the electric
parts assembly.
* Attach the lead dashboard also by inserting the
pawls of the lead covers into the square holes of
the lead cover
Work procedure
(M4 screws: 2 pieces)
(M4 screws: 2 pieces)
(M4 screws: 4 pieces)
(M4 screws: 4 pieces)
(M4 screw: 1 piece)
(No screw fixing)
TA sensor, PMV lead) of the control P.C. board.
Take of the lead wire from the clamp of the electric
parts box.
CN100...TC1 (3P; Brown)
CN101...TC2 (2P; Black)
CN102...TCJ (2P; Red)
CN104...TA (2P; Orange)
CN210...Fan motor (7P; White)
CN104...PMV (6P; Blue)
assembly fixing screws, slide the electric parts
assembly toward upper side, and then remove it.
(M4 screws: 2 pieces)
TC1, TC2, TCJ, TA sensors,
PMV lead
Clamp
Clamp
CAUTION
Be sure to put on the gloves at disassembling work;
otherwise an injury will be caused by a part etc.
and (1) to (8), attach
Control P.C. board
Fan motor lead
– 73 –
Remarks