Required Tools And Materials; Mounting The Device; Mounting The Device To A Rack - Siemens RUGGEDCOM RX1400 Installation Manual

Chapter 2
Installing the Device
• Section 2.8, "Cabling Recommendations"
Section 2.1

Required Tools and Materials

The following tools and materials are required to install the RX1400:
Tool/Material
LTE and/or GPS antennas
AC/DC power cord (16 AWG)
Lightning protector
Shielded coaxial cables
SIM Card(s) provided by the network carrier
Flathead screwdriver for mounting the device to a DIN rail
Phillips screwdriver for mounting the device to a rack or panel
Braided or equivalent ground wire for grounding the device
a
For more information, contact a Siemens Sales representative.
Section 2.2

Mounting the Device

The RX1400 is designed for maximum mounting and display flexibility. It can be equipped with brackets that allow
it to be installed in a 48 cm (19 in) rack, 35 mm (1.4 in) DIN rail, or directly on a panel.
NOTE
For detailed dimensions of the device with either rack, DIN rail or panel hardware installed, refer to
Chapter 5, Dimension
The following sections describe the various methods of mounting the device:
• Section 2.2.1, "Mounting the Device to a Rack"
• Section 2.2.2, "Mounting the Device on a DIN Rail"
• Section 2.2.3, "Mounting the Device to a Panel"
Section 2.2.1

Mounting the Device to a Rack

For rack mount installations, the RX1400 can be equipped with rack mount adapters pre-installed on the chassis.
CAUTION!
Electrical/mechanical hazard – risk of damage to the device. Before installing the device in a rack,
make sure of the following:
6
Drawings.
RUGGEDCOM RX1400
Installation Guide
Available For Purchase From Siemens
ü
û
û
û
û
û
û
û
Required Tools and Materials
a