Making Corrections To The Trace And Area Measurements; Stopping A Measurement Before Completion; Setting The Trace Resolution; Viewing The Patient Report - Siemens ACUSON Cypress Operator's Manual

Making Corrections to the Trace and Area Measurements

No matter which method you choose to use to perform the measurements, cor-
recting the Trace or Area outline is the same. Press the <
erase a small portion of the outline. Press and hold the <
continuously erase the path of the cursor until the <
released.

Stopping a Measurement Before Completion

To stop a measurement or sequence of measurements and return the cursor
to the currently displayed Calculation menu, press the <
completing the measurement.
To stop a measurement or sequence of measurements and exit the Calcula-
tion package, press the

Setting the Trace Resolution

The Resolution feature defines the spacing of the dots used to form the trace
outlines. To change the resolution, follow these steps:
Press , double-click the Calculations heading, and highlight Mea-
SETUP
1.
surements.
Specify resolution settings in the
2.
the Resolution pull-down menu, select a number from 1 to 8. A lower number
specifies a more vivid resolution (i.e., more dots); a higher number specifies
a less vivid resolution.

Viewing the Patient Report

There are two ways of viewing the Patient Report:
While in the calculation package, select Report from the calculation Selection
Menu.
At any time, press the
ACUSON Cypress™ Operator's Manual
Using the Cardiac Calculations Package
key before completing the measurement.
CALC
Area and Doppler Trace boxes. Using
2D
function key and click the Reports tab.
PATIENT
> key to
BACKSPACE
> key to
BACKSPACE
> key is
BACKSPACE
> key before
ESC
6-13