Wps Function; Reset Function; Factory Default Setting - LG TWFB-R101D Manual

5. Appendix

1. WPS Function

- You can use WPS to connect AP without any password(WPA or WPA2).
① Push AP' WPS button.
② Push PoE' WPS Button(During 3 secs).
③ When try to connect AP, WLAN LED is pulsing RED.
④ After connect AP, WLAN LED is blinking Yellow Green.
 If you didn't push PoE' WPS Button within 2min, It will be disconnected.
* Notice
- If you want to use WPS function, your AP must have WPS function.

2. Reset Function

- If you push RESET Button for 3secs, the PoE will restart.

3. Factory Default Setting

- Reset button can also be used to clear all data and restore the factory default settings.
① Press the Reset button(during 10 secs).
② Release the Reset button.
 PoE will return to the factory configuration
settings shown in the following table.
Copyrightⓒ. 2015. All Rights Reserved.
Feature
User name (case-sensitive) printed on product label
Password (case-sensitive) printed on product label
Static IP address
Ethernet MAC address
Subnet mask
DHCP client
Table 2. PoE default configuration settings
10 / 12
WPS
Reset
Fig 9. WPS / Reset
Default settings
admin
xxxxx
172.19.1.254
See bottom label.
255.255.255.0
Disabled