Home Network System Keychain Remote KX-HNK102FX Model No. Thank you for purchasing a Panasonic product. This document explains how to operate the keychain remote properly. For details about how to use the system, refer to the User’s Guide (page 12).
Table of Contents Important Information Accessory information ....3 About this system ......4 For your safety ......4 Important safety instructions ..5 For best performance ....5 Other information .......6 Setup Part names and functions ..8 LED indicator ......8 Setup overview ......9 Inserting the battery ....10 Attaching the key ring ....10 Registering the remote ....11 Wireless communication...
Important Information Accessory information Supplied accessories Accessory item/Part number Quantity Battery Key ring When replacing the battery, refer to the battery specifications noted under “Power source” on page 13. Other information R Design and specifications are subject to change without notice. R The illustrations in these instructions may vary slightly from the actual product.
Operating safeguards Panasonic will not be held responsible in the event that R Do not disassemble the product. property loss occurs while this system is in operation.
Hub location/avoiding noise leaking. The hub and other compatible R Exercise care when handling the Panasonic devices use radio waves to batteries. Do not allow conductive communicate with each other. materials such as rings, bracelets, or R For maximum coverage and...
Important Information antennas of mobile phone cell Disposal of Old Equipment and stations. (Avoid putting the hub Batteries (Only for European Union on a bay window or near a and countries with recycling window.) systems) R If the reception for a hub location is not satisfactory, move the hub to another location for better reception.
Page 7
Important Information Information on Disposal in other Countries outside the European Union These symbols (A, B) are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol This symbol (B) might be used in combination with a chemical symbol.
Setup LED indicator Part names and (Arm: Away) button functions Arms the alarm system using the [Arm: Away] mode. n Front view (disarm) button Disarms the alarm system. (smart) button Used to turn on a smart plug, trigger the alarm system, etc. Battery cover lock Battery cover Used to register the keychain...
Setup Indicator Status Confirm the usage area Read the information in this Red, blinking Remote is out of document to confirm that the range of the hub, or desired usage area is suitable to could not proper operation. communicate with the hub Green, Registration mode...
Setup Attach and lock the battery cover. Inserting the battery R After attaching the battery cover, rotate the lock to the R USE ONLY a CR2 Lithium battery. “locked” position. R Confirm the polarities ( R Using a metal object to open the lock may scratch the lock.
Setup Note: Registering the R To cancel without registering the remote, press M N on the hub and remote on the remote again. R If registration fails, the hub sounds This procedure is not required for several short beeps. devices that were included as part of a bundle.
Appendix Using the remote Features available when using the Changing the arm mode [Home Network] app Press the desired arm mode button. Some of the features that are available R The LED indicator lights for about 2 when using the [Home Network] app seconds according to the arm mode are listed below.
Specifications R Standards DECT (Digital Enhanced Cordless Telecommunications) R Frequency range 1.88 GHz – 1.90 GHz R RF transmission power www.panasonic.net/pcc/support/tel/ Approx. 10 mW (average power per homenetwork/manual/ channel) 250 mW (max.) R Power source Lithium battery CR2 (CR15H270) (1 ´ 3.0 V, 850 mAh) R Operating conditions 0 °C –...