GE IC754VSB06MTD Hardware User's Manual page 63

To remove the internal battery
1. Disconnect AC power from the DC supply.
2. Open the rear access panel.
3. Release the battery by gently lifting it from the completely exposed side,
past the small protrusions. To avoid breaking the battery retainer clips,
do not apply excessive upward pressure.
4. Slide the battery out of its carrier, noting the arrow on the carrier
indicating the direction of removal.
To install a new battery
1. Disconnect AC power from the DC supply.
2. Open the rear access panel.
Note: Battery must be installed with positive ( + ) side up.
3. To install the battery, insert one side of the battery into the upper side of
the battery clip, then press the other side into the clip until snaps into
place.
Replace battery with Panasonic BR2032 only. Use of another
battery may present a risk of fire or explosion.
Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
GFK-2327B
Warning
Warning
Chapter 3 Detailed Operation
3
3-35