Advertisement
MAJOR OPERATING CONTROLS AND THEIR FUNCTION
JOG BOARD
1. ISA connector
This connector is used to connect the personal comput-
er.
2. Interrupt number (IRQ) setting jumper (Pg)
Set the interrupt number (IRQ) where the jumper pin is
inserted.
3. I/O port setting jumper (P12)
Set the I/O address where the jumper pin is inserted.
4. RS422 control connector 1 (RS422-1)
This connector is used to connect a device that can be
controlled through a RS422 interface via the special
cable (accessory). This connection can be used to con-
trol recording and playback on a VTR.
5.RS422 control connector 2 (RS422-2)
This connector is used to connect a device that can be
controlled through a RS422 interface via the special
cable (accessory). This connection ca be used to con-
trol recording and playback on a VTR.
6. JOGPAD connector (JOGPAD)
This connection is used to connect a JOGPAD via the
special cable (accessory).
7. Time code, reference input/output connector
(LTC/REF)
This connector is used to connect, via the special time
code and reference I/O cable (accessory), with the time
code input and output on a VTR, etc., and with equip-
q
r
t
y
u
e
w
i
ment that inputs an external signal for synched compos-
ites (horizontal sync only).
• Time code input and output
This connector is used to connect with the time code
input and output on a VTR, etc. Make this connection
only if the VTR has a time code signal (LTC) output.
The time code output is not a loop-through of the signal
that was input on the time code input.
Ver. 1.0 software does not support time code input and
output.
• Reference input and output
This connector is used to connect with equipment that
inputs an external sync signal. Be sure to input the ref-
erence signal so as to maintain the frame precision. If a
reference signal is not input, video, audio, ant time code
synchronization, and time code I/O operation, cannot be
guaranteed.
through of the signal that was input on the reference
input.
8.Reference I/O 75-ohm terminator switch
No function.
When not using the REF OUT signal, turn off the switch
and connect the termination (accessory) to the REF
OUT cable.
The reference code output is a loop-
Advertisement
