Power Does Not Stay On Or The Phone Is Jammed - Nokia RH-64 Service Manual

RH-64
Baseband troubleshooting Nokia Customer Care
Figure 82 Easy flash programming fault

Power does not stay on or the phone is jammed

If this kind of a failure is presenting itself immediately after FLALI, it is most likely caused by ASIC's missing
contact with PWB.
If the MCU doesn't service the watchdog register within the UEMCLite, the operations watchdog will run out
after approximately 32 seconds. Unfortunately, the service routine can not be measured.
9243363 (Issue 1) Company Confidential Page 6–9
Copyright ©2005 Nokia. All Rights Reserved.