2Coaxial Cableconnector Connection Method - Mitsubishi Electric GOT2000 Series Connection Manual

1.4.2 Coaxial cableconnector connection method
The following describes the method for connecting the BNC connector (connector plug for coaxial cable) and the cable.
● Solder the coaxial cable connectors properly.
Insufficient soldering may result in malfunctions.
Components of the BNC connector
Plug shell
Step 1.
Remove the external sheath of the coaxial cable with dimensions as shown below.
Step 2.
Pass the nut, washer, gasket, and clamp through the coaxial cable as shown on the left and loosen the
external conductor.
Step 3.
Cut the external conductor, insulting material, and internal conductor with the dimensions as shown below.
Note that the external conductor should be cut to the same dimension as the tapered section of the clamp
and smoothed down to the clamp.
Step 4.
Solder the contact to the internal conductor.
1 - 24
1.4 Connection Cables for the Respective Connection
Nut Washer
Clamp
A
Cut this portion of the outer sheath
Cable in use
3C-2V
5C-2V, 5C-2V-CCY
Clamp
Nut
Washer
Gasket
Insulating material
Internal conductor
C
B
Clamp and external
conductor
Cable in use
3C-2V
5C-2V, 5C-2V-CCY
Solder here
CAUTION
Structure of the coaxial cable
Outer sheath
Gasket
Contact
External conductor
Insulating material
Internal conductor
A
15mm
10mm
B
6 mm
7 mm
C
3 mm
5 mm