This output cannot be used to daisy chain a second monitor. Serial I/O port RS232 The RS232 connector is only to be used with the monitor as stand alone. This connector allows you to control the monitor via your PC (as a replacement of the remote control).
Monitor Display modes 640x480 Wide VGA 848x480 Wide VGA 852x480 640x480 832x624 1024x768 1152x870 SVGA 800x600 1024x768 SXGA 1280x1024 Operation & Insert the mains plug supplied into the mains inlet at the back of the monitor and in the wall socket. For safety, please, only use the supplied rim-earthed mains cord which has to be inserted in a grounded socket.
¬ CH/PR AV MUTE End of life directives Philips is paying a lot of attention to produce environmentally-friendly in green focal areas. Your new monitor contains materials which can be recycled and reused. At the end of its life specialised companies can...
Use of the menus and the menu system Picture 1 Picture 2 Brightness Contrast Colour temp. Sharpness & Press the MENU key on the remote control to summon the different menu headers. é Press the cursor left/right to move the cursor horizontally through the menu headers.
Zoom factor Select Zoom factor and press the cursor left/right to adjust the zoom factor and to change the magnification of the picture. If zoom is not active, Zoom Off, changing the magnification factor will have no effect on the displayed picture.
Page 8
PC use you can turn on a screen saver in your computer. For video signals, Philips has built in an automatic shift of the picture every 5 minutes to avoid this effect and to prolong the life of the screen.