Note: Do not touch the adhesive on the sheet (the dark gray area).
7. With the adhesive facing toward you, insert the cleaning sheet on the left side of the printer until it
reaches the end of the roll paper feed slot, then pull it out. Repeat this two to three times. Repeat for
the center and right side of the roll paper feed slot.
Note: You can use a cleaning sheet only once.
8. Press the
Parent topic:
Related references
Optional Equipment and Replacement Parts
Replacing the Cutter
If you notice that your paper does not cut cleanly, you may need to replace the cutter.
Note: If the optional SpectroProofer is installed, remove it before replacing the cutter. See the
instructions that came with the SpectroProofer for details on removing it from your printer.
1. Remove any paper from the printer.
load paper button when complete.
Cleaning Your Product
156