Rear Panel - Sony BKM-17R Operating Instructions Manual

Rear Panel

 DC 12V connector
Connect to the DC 12V OUT connector of the monitor
by using the supported cables.
Supported cables vary depending on the monitor.
For BVM-E251/BVM-E171
The output cable of the supplied AC adaptor, SMF-
17R20, or the cable supplied with the controller
attachment stand such as BKM-37H
For another monitors
The output cable of the supplied AC adaptor
 LAN (10/100) connector (10BASE-T/100BASE-
TX)
Connect to the LAN (10/100) connector of the monitor
by using the SMF-17R20 or the cable supplied with the
controller attachment stand such as BKM-37H. Or
connect to the network or the LAN (10/100) connector
of the monitor by using a 10BASE-T/100BASE-TX LAN
cable (shielded-type, optional).
CAUTION
For safety, do not connect the connector for peripheral

device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
 When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
To connect the unit to the LAN (10/100) connector of

the monitor in 1 to 1 connection (NETWORK switch
is set to PEER TO PEER), use a straight (shielded-type)
cable.
 The connection speed may be affected by the network
system.
 NETWORK switch
LAN: To connect to the network.
PEER TO PEER: To connect to the LAN (10/100)
connector of the monitor in 1 to 1 connection.
12
Location and Function of Parts