Advertisement
•
Now, you will need to go ahead remove the flex cable ribbon from the phone. Be careful, it is holding place with
adhesive, so when you release it from the middle backing, it will take a little bit of effort. Do not tear the flex cable
ribbon doing this. \
•
Once this is complete you can now separate the LCD back plate from phone.
•
Next, using a hot air heat gun, gently heat up the sides of the digitizer touch panel. This will go ahead and loosen
up the adhesive holding your touch screen in place from the actual midframe of the phone.
•
Now, using your safe open pry tool, gently run along the sides of the touchscreen from the housing. This will allow
you to separate the touch screen glass from the actual midframe housing of the phone.
•
Once this is complete, you can now replace your touch screen digitizer on your Droid X2.
Your Motorola Droid X2 is now disassembled and ready for replacement of part(s). Reverse the
instructions above to reassemble your Droid X2.
Notice:
Repairs Universe's guides are for informational purposes only. Please
Learn about
restrictions on reproduction and re-use
creating hyperlinks to our guides.
click here for
of Repairs Universe's repair/take-apart/installation guides, and about
details.
Advertisement
