Service Test Mode; Common Operation Mode For Only Standby Sources; Display Content - Kenwood KDC-202U Service Manual

4.1.5 Service Test Mode

In the STANDBY source, while pressing and holding [2] key, press [6] key for 7 seconds.
(Starting to press [2] key and [6] key at the same time can not be entered into the mode)
Default status immediately after the mode activation
It shall be same as the normal activation.
Mode structure
Service Test Mode is enabled only STANDBY source.
Mode content
Syscom shall display the following information after entering this mode. The operation shown below shall be workable.

Display content

S R V T E S T

Common operation mode for only STANDBY sources

Operation
Development name
1
status display
Power ON duration
3
display
Disc action duration
4
display
Disc Eject number of
5
times display
Disc Eject number of
5
times clear
Forced Power OFF
information display
Forced Power OFF
info clear
The display is released when another operation is executed.
Display content
1 1 1 3 W E 2 –
P O N T M 0 H
P O N T M x x
C D T M 0 H
C D T M x x
E J C N T x x
E J C N T 0 0
P O F F – – –
P O F F P N L
P O F F – – –
(No.WA002<Rev.001>)16/20
Details
Development name - Version (Micom)
2
00~50 are displayed in "∗ ∗".
For less than 1 hour, the display is indicated per 10
x x
minutes.
00001~10922 are displayed in "xxxxx".
MAX 10922 (hours)
x x x
0~50 are displayed in "∗ ∗".
For less than 1 hour, the display is indicated per 10
x x
minutes.
00001~10922 are displayed in "xxxxx".
x x x MAX 10922 (hours)
Display Disc Eject number of times.
MAX 65535 (times)
x x x
Clear Disc Eject number of times by pressing for 2
seconds when it is displayed.
0 0 0
No forced Power OFF
Forced Power OFF due to Syscom-Panel communica-
tion error.
Clear forced Power OFF information by pressing
for 2 seconds when it is displayed.
Details