Entering Basic Settings
•
•
Step 14
Use the Ensure Compatibility With setting to automatically configure the Access
Point to be compatible with other devices on your wireless LAN:
•
•
Step 15
Press sn and then press Enter to select SNMP Admin. Community. Enter an
SNMP community name. This name automatically appears in the list of users
authorized to view and make changes to the Access Point's management system.
You can define other SNMP communities with User Management. The "Security
Setup" section in Chapter 3 of the Cisco Aironet Access Point Software
Configuration Guide describes User Management.
Step 16
Press ap and press Enter to apply your basic settings. If you changed the Role in
Radio Network setting, your Access Point reboots.
Cisco Aironet Access Point Hardware Installation Guide
3-12
Range—Press r and then press Enter to select this setting. Maximizes the
Access Point's range but might reduce throughput.
Custom—Press c and then press Enter to select this setting. The Access Point
will use the settings you enter on the AP Radio Hardware page. Chapter 3 of
the Cisco Aironet Access Point Software Configuration Guide describes the
AP Radio Hardware page.
2Mb/sec clients—Press 2 and then press Enter to select this setting. Select
this setting if your network contains Cisco Aironet devices that operate at 2
Mbps.
non-Aironet 802.11—Press no and then press Enter to select this setting.
Select this setting if there are non-Cisco Aironet devices on your wireless
LAN.
Chapter 3
Basic Configuration
OL-0738-01