Epson Artisan 810 Service Manual page 128

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Align the positioning holes (x1) of the Main Board Unit with the
dowels (x1) of the Base Frame. (See
Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Holder IC Shield Plate. (See
4-42.)
Align the dowel (x1) of the Main Board Unit with the
positioning hole (x1) of the Right Cable Frame. (See
Insert the rib (x1) of the Grounding Plate M/B to the hole of the
Main Board Unit, and align the positioning hole (x1) of the
Grounding Plate M/B with the dowel (x1) of the Main Board
Unit, and then attach the Grounding Plate M/B. (See
Fig. 4-43.)
Figure 4-43. Attaching the Grounding Plate M/B
DISASSEMBLY/ASSEMBLY
Fig. 4-42.)
Fig.
Fig. 4-42.)
Fig. 4-42,
Grounding Plate M/B
Rib
Hole
Disassembly Procedures
When attaching the CR Encoder FFC, follow the procedure
below.
1. Put the CR Encoder FFC through the ferrite core.
2. Connect the CR Encoder FFC to the connector (CN6) on
the Main Board.
3. Insert the rib of the Ferrite Core Holder B to the hole of the
Main Board, and secure it with the screw (x1).
Align and insert the rib of
the Ferrite Core Holder B
CR Encoder FFC
Figure 4-44. Attaching the CR Encoder FFC
For routing cables and FFCs, see
(p.196).
Revision G
Ferrite Core Holder B
CN6
Ferrite core
C.B.S. 3x6 (5±0.5Kgfcm)
"4.4 Routing FFC/cables"
128
Confidential