Table of Contents
Advertisement
Configuration
3.
4.
5.
Callback Center Setup Screen
You can set up the DVR to contact a computer running RAS (Remote Administration
System) and send an E-mail on a LAN when an event occurs. You can also set it up to
dial a pager with a numeric message when an event occurs if you have a modem
connected to the DVR.
Callback Center Setup by LAN Connections
Access the Callback Center Setup screen (MENU
Center).
1.
2.
3.
4.
Rev 1.00
Highlight the box beside Data Bit of the RS232 field. Press
7 bit and 8 bit formats.
Highlight the box beside Stop Bit of the RS232 field. Press
1 and 2 Stop Bits.
To save your changes, highlight OK and then press
screen without saving the changes.
Figure 3-46
Highlight the box beside IP Address and enter the IP address of the computer
you want contacted during an event.
Highlight the box beside Retry and enter the number of times you would like
the DVR to try contacting the computer. You can select from 1 to 10 retries.
Highlight the box beside E-mail notification and then press
between On and Off.
Highlight the box beside SMTP Server IP and enter the SMTP server IP
address, obtained from your system administrator.
Callback Center (LAN) Setup Screen
65
to toggle between
to toggle between
. Select Cancel to exit the
Network
Callback
to toggle
Document 900.0258
09/04
Advertisement
Table of Contents
