Electrolux XLCE User Manual page 21

50 Hz to 60 Hz dryer conversion
This laundry center was delivered from the manufacturer as
a 50 Hz appliance. To get the maximum effi ciency from this
dryer when operating on 60 cycle alternating current, the mo-
tor pulley must be positioned with the smooth end away from
the motor. The belt must run in the set of grooves closest to
the motor.
Belt Must Be Run
In Set of Grooves
Closest to Motor
60 Hz to 50 Hz dryer conversion
To get the maximum effi ciency from this dryer when operat-
ing on 50 cycle alternating current, the motor pulley must be
positioned with the grooved end away from the motor. The
belt must run in the set of grooves closest to the motor.
Belt Must Be Run
In Set of Grooves
Closest to Motor
Smooth End Away From
Motor for 60 Hz.
Grooved End Away From
Motor for 50 Hz.
Water inlet
Do not use the hose from your previous appliance to connect to
the water supply.
1. Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring nut
again to prevent water leaks.
Water drainage
The drain hose must not be kinked. The end of the drain
hose can be positioned in these ways:
Directly into a drain pipe at a height of not less than 85 cm
and not more than 200 cm. The end of the drain hose must
2. Connect the hose to a tap with
a 3/4" thread. Always use the
hose supplied with the ap-
pliance. The inlet hose must
not be lengthened. If it is too
short and you do not wish to
move the tap, you will have to
purchase a new, longer hose
specially designed for this type
of use.
Hooked over the edge of a sink.
In this case, make sure the end
cannot come unhooked when the
machine is emptying.
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of
the drain hose.
21