Lifting/Lowering The Motor Head; Attaching/Removing The Flat Beater, Wire Whip, Or Dough Hook - KitchenAid 5KSM150PS Instructions Manual

aSSEmblINg thE StaND mIxEr

lifting/lowering the motor head

to lift motor head: Push the locking
1
lever to the UNLOCK position and lift
the head. Once lifted, the lever will
automatically go back in LOCK position
to keep the head lifted.
NOtE: Motor head should always be in LOCK position when using the Stand Mixer.

Attaching/removing the flat beater, wire whip, or dough hook

Hold the locking lever in the UNLOCK
2
position and tilt motor head back.
10
W10572619A_01_Final.indd 10
to put down motor head: Push the
2
locking lever to UNLOCK and gently
bring the head down. The locking lever
will automatically go back in LOCK
position when the head is down. Before
mixing, test lock by attempting to raise
motor head.
to attach accessory: Turn speed
1
control to "O". Unplug Stand Mixer.
Slip accessory onto beater shaft and
3
press upward as far as possible. Then,
turn accessory to the right, hooking
accessory over the pin on the shaft.
aS
4/12/13 8:41 AM