Electrical Safety - Bosch ALS 25 Original Instructions Manual

OBJ_BUCH-2977-001.book Page 5 Wednesday, July 27, 2016 9:38 AM
 Do not vacuum solid objects such as
big branches, broken glass, pieces of
metal and stones.
 A worn fan or blower housing (chips,
cracks, nicks) may cause an increa-
sed risk of injury from thrown foreign
objects. If the blower housing is da-
maged, consult the Bosch hotline.
Remove the plug from the socket:
– Whenever you leave the machine.
– Before checking, clearing a blockage
or working on the leaf blower/garden
vacuum.
– After striking a foreign object, inspect
the leaf blower/garden vacuum for
damage and make repairs as neces-
sary.
– If the leaf blower/garden vacuum
starts to vibrate abnormally check im-
mediately.
Connecting to the mains
 The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
 We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
 Only use or replace power supply
cables for this unit which correspond
to the types indicated by the manu-
facturer. See the operating instruc-
tions for the order no. and types.
 Never touch the mains plug with wet
hands.
Bosch Power Tools
 Do not run over, crush or pull the po-
wer supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
 The extension lead must have a cross
section in accordance with the opera-
ting instructions and be protected
against splashed water. The connec-
tion must not be in water.

Electrical Safety

 Motor Protector fitted! Motor fit-
ted with safety overload protec-
tion. If motor stops working, allow
a few minutes to cool, before rest-
arting.
 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is entangled.
 If a cord becomes damaged during
use, disconnect the supply cord
from the mains immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use appro-
ved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
English | 5
F 016 L81 596 | (27.7.16)