Edit Menu; Active Function Blocks; Fast Editing Mode; Select Functions - ABB CAP 505 User Manual

1MRS751982-MUM
2.3.3.
2.3.3.1.
2.3.3.2.
2.3.3.3.
2.3.4.
ABB Automation
Protocol Editing Tool
User's Guide

Edit menu

The following figure shows the components of the Edit menu of the POD tool. The
greyed functions are disabled when working in basic mode.
)LJ  7KH HGLW PHQX

Active function blocks

Each signal belongs to a function block. The function blocks can be active or
inactive (cell texts of InActive function blocks are in italic . In the "Active
Function Blocks" dialog, you choose which function blocks should be active and
inactive. The viewing options for visible functions block are found in the "Edit"
menu.
You find more information about the active function blocks in Chapter 3.5.

Fast editing mode

If Fast Editing Mode is chosen, you can change the cell values of the chosen cells in
one column at the same time. More information about the fast edit mode is found in
Chapter 3.3.3.

Select functions

The last four menu functions in the Edit menu are select functions. This means that
rows are selected according to one of the below mentioned alternatives. The
different alternatives are:
• Select rows of Active Function Blocks.
• Select rows of InActive Function Blocks.
• Select In Use rows, based on the "In Use" column data.
• Select NOT In Use rows, based on the "In Use" column data.

View menu

The view menu contains two toggle menu item groups
CAP 505
2. Using the Protocol Edit-
ing Tool
2
7