Section 1: Configuring The Relay Using Reydisp Evolution; Physical Connection; Front Usb Connection; Figure 2.1-1 Usb Connection To A Pc - Siemens 7sr220 Configuration Manual

7SR210 & 7SR220 Configuration Guide

Section 1: Configuring the Relay Using Reydisp Evolution

To set the relay using the communication port the user will need the following:-
PC with Reydisp Evolution Installed. (This can be download from our website
found under the submenu 'Software'). This software requires windows 2000-service pack 4 or above, or windows
XP with service pack 2 or above.
1.1

Physical Connection

The relay can be connected to Reydisp Evolution via any of the communication ports on the relay. Suitable
communication Interface cable and converters are required depending which port is being used.
1.1.1

Front USB connection

To connect your pc locally via the front USB port.
Page 10 of 14

Figure 2.1-1 USB connection to a PC

www.siemens.com/energy
©2011 Siemens Protection Devices Limited
and