Installing An Extension Or Trunk Blade; Installing The Blades; Figure 4-3 Inserting Blades In The 19" Chassis; Figure 4-4 Inserting Blades In The 9.5" Chassis (Au Only) - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
2.2
4 - 4

Installing an Extension or Trunk Blade

2.2.1

Installing the Blades

To install an extension/trunk blade with the system running:
1. Insert the blade in the guide rail and push it securely into
position. Tighten the thumb screw on either side of the blade.
2. The Status LED starts flashing when the blade starts
processing (15 seconds).

Figure 4-3 Inserting Blades in the 19" Chassis

Figure 4-4 Inserting Blades in the 9.5" Chassis (AU Only)

UNIVERGE SV8100
Installing the SV8100 Blades