Technical Data; Intended Use; Delivered Items - Bosch AKE 30-19 S Operating Instructions Manual

F 016 L70 558.book Seite 3 Donnerstag, 15. Januar 2009 3:18 15
Kickback is the result of tool misuse and/or incorrect
operating procedures or conditions and can be
avoided by taking proper precautions as given be-
low:
Maintain a firm grip, with thumbs and fingers
encircling the chain saw handles, with both
hands on the saw and position your body and
arm to allow you to resist kickback forces.
Kickback forces can be controlled by the opera-
tor, if proper precautions are taken. Do not let go
of the chain saw.

Technical data

Chain saw
Part number (typ)
Tool-less chain tensioning (SDS)
Rated power
Chain speed (no load)
Chain bar length
Nose sprocket
Kickback Brake
Run down brake
Chain type
Drive link thickness
Amount of drive links
Oil reservoir capacity
Automatic oiler
Metal gripping teeth
Weight without mains cable. approx. **
Protection class
**measured with chain bar and chain
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.

Intended Use

The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your chain saw. It is impor-
tant that you read these instructions carefully.
8 • F 016 L70 558 • TMS • 08.01.09
Do not over reach and do not cut above shoul-
der height. This helps prevent unintended tip
contact and enables better control of the chain
saw in unexpected situations.
Only use replacement bars and chains speci-
fied by the manufacturer. Incorrect replacement
bars and chains may cause chain breakage and/
or kickback.
Follow the manufacturer's sharpening and
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to in-
creased kickback.
AKE 30-19 S AKE 35-19 S
3 600 H36 D.. 3 600 H36 E..
[W] 1900 1900
[m/s] 12 12
[cm] 30 35
–
3/8" - 90 3/8" - 90
[mm] 1.1 (0.043") 1.1 (0.043")
45 52
[ml] 200 200
[kg] 4.2 4.3
/ II

Delivered Items

Carefully remove the machine from its packaging
and check for complete contents:
– Chain saw
– Cover plate
– Chain
– Chain bar
– Chain guard
– Chain oil (80 ml)
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
English - 3
AKE 40-19 S
3 600 H36 F..
1900
12
40
3/8" - 90
1.1 (0.043")
57
200
4.4
/ II / II