Panasonic dp-100 series Instruction Manual page 5

10 MENU SETTING MODE
Item Description
Comparative output 1 Sets operation of comparative output 1.
mode setting
Comparative output 2 Sets operation of comparative output 2.
mode setting
(Standard type only)
Analog voltage output / Selects analog voltage output, auto-refer-
external input ence input, or remote zero-adjustment
(Multifunction type only) input.
N.O. / N.C. selection Selects normally open (N.O.) or normally
closed (N.C.).
Response time setting Sets response time in milliseconds (ms).
Response times available: 2.5, 5, 10, 25,
50, 100, 250, 500, 1000, 5000ms
Display color for the Selects color of main display.
main display
Pressure unit selection Selects desired pressure unit.
From RUN mode, press MODE for 2s to select the menu setting mode.
The examples below begin with the factory default settings.
<RUN mode>
MODE Press 2s.
<Mode setting for comparative output 1>
Hysteresis
EASY mode
mode
MODE

Standard type
<Mode setting for comparative output 2>
OFF mode EASY mode

Multifunction type
<Analog voltage output / external input>
Analog voltage Auto-reference
output input
MODE

Standard type
1, 2
<N.O. / N.C. selection>
Output 1: N.O. Output 1: N.C.
Output 2: N.O. Output 2: N.C.

Multifunction type
<N.O. / N.C. selection>
N.O. N.C.
MODE
1
If for the standard type DP-100 comparative output 2 is set to "OFF", the N.O. /
N.C. selection (normally open, normally closed selection) is the same as for the
multifunction type, i.e. you will only set N.O. or N.C. for comparative output 1, not
for both comparative outputs.
2
The default setting of the high pressure type is N.O. (normally open), and that of
the low pressure type is N.C. (normally closed).
SEN TRONIC
AG
Produkte, Support und Service
Window
comparator
mode
1
Hysteresis Window
mode comparator
mode
Remote
zero-adjustment
input
Output 1: N.O. Output 1: N.C.
Output 2: N.C. Output 2: N.O.
Rugghölzli 2
CH - 5453 Busslingen
<Response time setting>
(2.5ms) (5ms)
MODE
<Display color for the main display>
Red when ON Green when ON
Green when OFF Red when OFF
MODE
3, 4
<Pressure unit selection>
(MPa) (kPa)
MODE
(inchHg)
<Run mode>
3
The default setting for the low pressure type is kPA. MPA is not available.
4
For the high pressure type, "inchHg" and "mmHg" are not available.
5
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
(5000ms)
Always red Always green
(kgf/cm 2 ) (bar)
(mmHg) (psi)
mailbox@sentronic.com
www.sentronic.com