Check Handset Functionalities; Start Up Not Successful; Check Lan Connection; Determine The Software Version - Siemens optiPoint 410 Administrator's Manual

Administration scenarios

Check handset functionalities

•
•
•

Start up not successful

Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410 being run in a Æ VLAN ?
•
Is the optiPoint 410 being run behind a Æ Gateway?
•
Other configuration possibilities ...

Check LAN connection

•
•

Determine the software version

You can determine the version of the software that is running the
optiPoint 410, e.g., during a pending software update.
•
90
Check whether the plugs at the two ends of the handset cable are in-
serted correctly (handset engaged) Æ page 10.
Carry out an Audio Loop test.
– More information on " Audio Loop Test" Æ page 67.
Æ page 41
–
Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions of the
optiPoint 410.
Enter the VLAN ID manually, or, if a Æ DHCP server is being used, set
the "VLAN Discovery Mode" Æ page 81 on "DHCP" , so that the VLAN
ID transferred from the DHCP server is used.
– More information on "Virtual LAN ID" Æ page 81.
Æ page 24
–
Enter the Æ IP address of the Gateway in Æ Default Route.
Æ page 21
–
Check whether the plugs at the two ends of the LAN cable are correct-
ly inserted (handset engaged) Æ page 10.
Check the connection with the help of the PING test.
– More information on "PING Test" Æ page 78.
Æ page 42
–
Æ page 39 Æ page 54
Æ page 59
Æ page 58
Æ page 61
Setting up the FTP server