Valves And Cylinder Head - Suzuki Grand Vitara XL-7 Service Manual

6A3-32 ENGINE MECHANICAL (RHZ ENGINE)

VALVES AND CYLINDER HEAD

1. Valve cotters
2. Valve spring retainer
3. Valve spring
4. Valve stem seal
5. Valve spring seat
6. Intake valve
7. Exhaust valve
8. Cylinder head bolt:
Replace bolt if it is longer
than specified valve.
9. Cylinder head
10. Cylinder head gasket:
"Thickness Identification"
mark provided on gasket should
come to high pressure fuel
pump side.
11. Knock pin
REMOVAL
1) Disconnect negative cable at battery.
2) Remove timing belt referring to "TIMING BELT AND BELT TEN-
SIONER" in this section.
3) Remove engine bracket (1) from cylinder head and cylinder
block.
4) Remove intercooler bracket (1), radiator inlet hose (6), heater in-
let pipe (2), vacuum pipe (3) and heater outlet pipe (4) with
hoses.
5) Disconnect each connector and detach wire harness protector
(5).
.
60 N m (6.0 kg-m, 43.5 lb-ft)
8
and retighten 220_
: Tightening Torque
: Do not reuse
: Apply engine oil to sliding
: surface of each part.