Custom Led Labeling - GE C70 Instruction Manual
Capacitor bank protection and control system
Hide thumbs
Also See for C70:
- Instruction manual (708 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (702 pages)
Table of Contents
Advertisement
FRONT PANEL INTERFACE
USER-PROGRAMMABLE LEDS
Default labels for LED panel 2
The default labels are intended to represent the following:
•
GROUP 1...6 — The illuminated GROUP is the active settings group
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained in
4
the next section.
4.2.8 Custom LED labeling
4.2.8.1 Enhanced faceplate
The following procedure requires these pre-requisites:
•
EnerVista UR Setup software is installed and operational
•
The C70 settings have been saved to a settings file
•
The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded from
http://www.gedigitalenergy.com/products/support/ur/URLEDenhanced.doc
•
Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1.
Start the EnerVista UR Setup software.
2.
Select the Front Panel Report item at the bottom of the navigation menu for the settings file. The front panel report
window displays.
4-20
Figure 4-22: LED panels 2 and 3 (index template)
Figure 4-23: LED panel 2 (default labels)
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
USER-PROGRAMMABLE LEDS
and printed
CHAPTER 4: INTERFACES
842782A1.CDR
Advertisement
Table of Contents
