Craftsman 10134 Operator's Manual page 8

STEP (9):
BB(1) EE(1)
J J(1)
Cabinet MUST be attached to a stud in a wood frame wall.
Failure to do so may cause personal injury or product
damage.
Hardware is provided for wood frame wall use only.
Concrete or other surfaces will require other hardware (not
provided). Use appropriate hardware per your local
building codes. Failure to do so may cause personal injury
or product damage.
Note: Mounting bracket may be mounted on either side of the
cabinet. Mounting shown on left side.
• Place mounting bracket (H) in desired mounting location on
side of cabinet. Mark center of mounting hole location, using
slots in bracket as a template.
• Remove bracket. Drill 1/4" mounting hole in side of cabinet.
• Mount bracket (H) to cabinet using (1) screw (BB) and (1) nut
(EE).
• Finger tighten.
EE
BB
t
• Align cabinet with a stud. Adjust leveler feet if needed.
• Drill 1/8" pilot hole in stud.
• Attach cabinet to stud using screw JJ.
• Wrench tighten screw holding bracket to cabinet.
JJ
f
Shelf Adjustment
• Empty shelf.
• Remove fasteners.
• Rotate shelf upward and putt forward, as shown.
• Move shelf to desired location.
• Insert back of shelf in notches, rotate shelf into place and
reinstall fasteners.
Leveling Foot Adjustment
• Adjust leveling foot to desired position with flat head
screwdriver or 1/2" open end wrench as shown.
j ....................... i-i ....
f I ,.L
/ . \
\,
_:z L ',,
',\
',\
I
/
/
/
/
/
/
.... _ ................... z --j
• Periodically the surfaces should be cleaned with a mild
• detergent and water. |
Grease and oil can be removed with most standard cleaning |
fluids. For safety, use a nonflammable cleaning fluid. |
• Auto wax will preserve the units luster finish. Apply the wax as I
to a car. The wax wilt also help protect the unit against |
scratches. J
_, ,_"