Memory Module Upgrade - Haier X3 PRO User Manual

MEMORY MODULE UPGRADE

To increase your notebook's memory capacity (up to 8 GB maximum), additional memory modules
may be installed. The memory upgrade must be a dual-in-line (DIMM) SDRAM module.
Installing a Memory Module
The following steps describe how to install a memory upgrade module. We do not recommend
that you do this yourself.
1. Turn off power to your notebook using the power switch, disconnect the power adapter,
and/or remove the battery pack.
2. Place your notebook upside-down on a
clean work surface.
3. Slide open the battery lock. Slide and hold
the battery release latch in the open position
and use the other hand to slide the main
compartment cover toward the front of the
system. Once the cover is released from the
securing tabs, lift it away from the system.
4. The memory upgrade module can be
severely damaged by electrostatic discharge
(ESD). Be sure you are properly grounded when handling and installing the module.
5. Align the connector edge of the memory upgrade module, chip side up, with the connector
slot in the compartment.
6. Insert the memory upgrade module at a 45
7. Press the memory upgrade module down into the compartment until it locks into the retaining
clips on either side. You will hear a click when it is properly in place. If you are using two
memory modules, repeat steps 5 to 7 for the other slot.
8. Replace the cover and slide downward and toward the back of the system until it clicks into
place. Installation of the new memory module is now complete.
The memory upgrade module is not something you routinely remove from your notebook PC.
Once it is installed, you should leave it in place unless you want to increase system memory capacity.
GETTING STARTED
angle and press it firmly onto the connector.
o
21