Automatic Sp/Lp Selection; Vps/Pdc Function; Timer Recording - Panasonic Hi-Fi) Operating Instructions Manual

Timer recording

SV120 HV60 HV50 MV15
Automatic
A: If, at the beginning of a timer programme, there is not enough tape remain
to complete it, the SP/LP function will automatically run the tape at LP speed.
This ensures that the entire programme will be recorded. If the LP mode is
not enough to 'stretch' the remaining tape to fit you will not be able to record
all of the TV programmes.
D
It is not possible to automatically activate the EP mode.
SV120 HV60

VPS/PDC function

This setting defines how a special signal controls the beginning and end of
VPS/PDC
a recording session. If a TV programme begins or ends earlier or later than
planned, this function synchronises the beginning and end of the recording
session with the actual beginning and end of the TV programme.
ON : The station transmits VPS/PDC signals. You must set the timer to the
time specified in the TV magazines. Use the special VPS time the TV
magazine may indicate.
- - - : The station does not transmit VPS/PDC signals. Try to set the start and
stop time such that the entire film can be recorded even if a programme
begins or ends earlier or later than planned.
SP/LP selection
HV50 MV15
11