Philips XZ5800 Manual page 29

Problem
I replaced
the shaving
heads, but the
replacement
reminder is still
showing.
A shaving
head symbol
has suddenly
appeared on the
display.
Water is leaking
from the bottom
of the appliance.
The nose
trimmer
attachment pulls
at the hairs.
Possible cause
You have not reset
the appliance.
This symbol is
a replacement
reminder.
During cleaning,
water may collect
between the inner
body and the
outer shell of the
appliance.
You move the
appliance too fast.
Solution
To clean the shaving heads
thoroughly,
remove the shaving heads
from the shaving head
holder one by one (see
'Replacement'). Then
separate the cutter from
its guard and rinse each
matching set under the
tap. After rinsing, place
the cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder
(see 'Replacement').
Reset the appliance by
pressing the on/off button
for approx. 7 seconds.
Replace the shaving heads
(see 'Replacement').
This is normal and not
dangerous because all
electronics are enclosed in
a sealed power unit inside
the appliance.
Slowly move the
attachment around to
remove all unwanted hairs
in your nostrils.
English
29