Save The Layout; Configure A Dynamic Layout - Canon RM-Lite Administrator's Manual

Save the Layout

After configuring the display and position of the video
windows, follow these steps to save the layout.
Click [File] > [Save Layout].
1
Change the layout name as required, and click [OK].
2

Configure a Dynamic Layout

1 Click [Layouts] > [New Dynamic Layout] to display the
[New Dynamic Layout] dialog box.
Specify the criteria for the video windows displayed in
2
the dynamic layout.
➀
➁
➂
➀ [Layout Name]
Enter the name of the dynamic layout.
➁ [Display cameras that]
Specify the display criteria for cameras.
Click a check box to make a set of display criteria
available, and then click each criteria list to select the
criteria.
You can specify up to five sets of criteria.
The criteria are (from left to right), the property,
operator, and status.
Property
Property
Tags
Status
Event Type
Event Priority
Storage
Server Group
Select [All of the following are met] to display only
cameras that meet all the criteria. Select [Any of the
following are met] to display cameras that meet any of
the criteria.
➂ [When conditions are not met, continue displaying
cameras for]
Specify how long a video window in the layout will
remain displayed when it does not match the criteria
specified here.
➃ [OK] and [Cancel]
Close the dialog box.
➃
3 Click [OK] to close the dialog box.
Click [File] > [Save Layout].
4
Change the layout name as required and click [OK].
5
Configure the Video Window Layout
Status
Operator
Operator for the
Status
decision
is Camera tags
isn't
is Camera status
isn't (such as
[Recording],
[Idle], or [Error])
is Event type (such
isn't as [Motion] or
[Sensor])
is Event priority
is equal or higher than ([Highest], [High],
is equal or lower than [Medium], [Low],
or [Lowest])
is The name of
isn't Storage Server
Group to which
the Viewer is
connected.
4
67