Make Station Assignments On Cix - Toshiba Strata CIX Installation Manual

Software Installation
Strata CIX Database Programming

Make Station Assignments on CIX

This procedure is for programming a digital station as the attendant console speech path. If you
are setting up an IP attendant console (and do not want a digital station option) skip to
Assignment" on page
1. Digital Station Assignment:
a. Select Station > Station Assignments (Program 200), specify the Prime DN for this
b. Enter data for the FBs listed below:
FB
PDN Equipment Number
01
slot/port) required for assigning a new DN to the system.
02 Station Type -
03 Circuit Type -
COS Day1/Day2/Night -
at the following three prompts: "COS DAY1=
04
DAY2=
Dialing Progress Tone -
11
heard after LCR access codes are dialed
All other FBs may be set according to the customer's preference
p
p
p
p
p
2. Make DKT Data Assignments on CIX
a. Select Station > Station Assignments > DKT Tab (Program 204), enter the Prime DN for
3. Enter data listed below:
p
p
p
2-12
2-13.
particular Attendant Console. The number entered here is the DN used to reach this
Do not use 0 as the Prime DN.
specific console.
Destination" on page 18.
or station.
Required Feature Settings
-Specifies the equipment number (shelf/
to assign the DKT Station type
assign Extension attributes to ports
Toshiba recommends entering COS 10
10
" and "COS Night=
assign Dial Tone as the type of tone
01 – Specifies the equipment number (shelf/slot/port) required for assigning a new DN to
the system. Set the CIX Attendant Console DN to the BDKU\BDKS or BWDKU port
(required).
02 – Select DKT Station type (required).
03 – Select Extension (not Voice Mail).
04 – Toshiba recommends entering COS 10 at the following three prompts:
"COS DAY1=10", "COS DAY2=10" and "COS Night=10" (preferred).
11 – Select Dial Tone - selects Dial Tone as the tone heard after LCR access codes are
dialed.
this particular Attendant Console.
01 – Assign the Station Type as "Attendant" (required).
02 – Select 3 to assign the key strip assignments for the Attendant Console (required).
05 – Select Tone First signaling (required).
Do not assign the Attendant Console PDN to another DKT
Description
10
", "COS
10 (as per programmed in Prog 103)
Strata CIX PC Attendant Console Installation
Dial 0 is set in "Create Dial 0
Setting
xxyyzz
DKT
Extension
10/10/10
Dial Tone
"IP Station
06/09