Names Of Controls And Terminals; Diver Setting - Panasonic CY-TUN153U Operating Instructions Manual

Names of Controls and Terminals

TV Tuner Unit
15
TV ANT IN
Terminal for connecting TV antennas (supplied)
TO HEAD UNIT/EXPANSION MODULE
(System-up Connector)
Terminal for connecting a Head Unit (CQ-VD7003U, CQ-
VD6503U, option)/Expansion Module (CY-EM100U,
option).
POWER SUPPLY
Terminal for connecting to the power connector
Remote Control Unit
[PWR] (Power)
 Switches on/off the power. (page 18)
[BAND]
 Selects TV band. (page 18)
 Searches for channels and memorizes
them automatically. (page 19)
[] (CH DOWN) [] (CH UP)
 Selects an operation or item. (page 17)
 Selects or searches the channel. (page
18)
16 CY-TUN153U
REMOTE IN (Black)
TV OUT
Terminal for connecting a
Terminal for connecting a Rear
Head Unit's remote output
Monitor (CY-VHD9401U, etc.,
option). terminal.
L (White) R (Red)
VIDEO (Yellow)
Connect RCA cord to the video input terminal of the
Head Unit when connecting Head Unit/Expansion Module
Connecting Cable to the Head Unit.
Note:
 Point the emitter of the remote controller at the Head
Unit or the monitor.
[ENT] (ENTER)
 Determines an operation or item. (page 17)
 Shows TV channel display. (page 18)
[MENU]
 Shows the menu screen. (page 17)
[] [] (PRESET)
 Selects the preset channel. (page 19)
 Sets the preset channel writing/deleting
mode. (page 19)

DIVER Setting

Refer to page 12 about the DIVER (Diversity) Antenna
setting.
Read the explanation on this page as required.
[PWR] (Power) [ENT] (ENTER)
[MENU]
[] []
DIVER (Diversity) Antenna Setting
Diversity TV Antenna:
Of the two antennae connected to the system, the one
with the best reception is automatically selected for TV
reception. Turning DIVER (Diversity) setting to "ON"
reduces noise.
Confi rm "ON" to receive a good reception.
Default: ON
Setting: ON/OFF
 Press [PWR] (Power).
 Press [MENU].
 Press [] or [] to select "ON" or "OFF".
 Press [ENT] (ENTER) or [MENU] to set and return to
the previous display.
Note:
 Only English is displayed on the OSD screen.
CY-TUN153U
16
17