Page 1
PT-DW6300S/DW6300K P ro d u c t N u m b e r : PT-DW6300LS/DW6300LK P ro d u c t N a m e : As of February 2009. Specifications subject to change without notice. The PT-DW6300LS and PT-DW6300LK are not equipped with a lens.
DVI-D I N RGB 2 Input DVI-D input LAN connector unit : mm (inch) NOTE: This illustration is not drawn to scale. The illustration shows the PT-DW6300S/DW6300K. Remote 1 input Remote 1 output Remote 2 input 10 Serial input 11 Serial output...
PT-DW6300S/DW6300K/DW6300LS/DW6300LK ™ Projectors Standard setting-up position (when installed using the ET-PKD56H) Upper edge of projected image Projected image Lower edge of projected image Projected image C A U T I O N The ET-DLE055 has a fixed short-focus lens. Therefore, the lens shift function provided in the main unit cannot be used.
PT-DW6300S/DW6300K/DW6300LS/DW6300LK ™ Projectors Calculation of the projection distance For a screen size different from the above, use the equation below to calculate the projection distance. Aspect ratio 16:10 ET-DLE150 minimum maximum Supplied lens minimum maximum ET-DLE250 minimum maximum ET-DLE350 minimum...
Page 9
• Floor mount (Width of projected image) 0.1H Installable angle Install the projector at an angle within the range shown below. • Vertical direction The projector may be installed at a vertical angle of 360°. As of February 2009 • Ceiling mount 0.1H...
Page 10
NOTE: The native resolution of this projector is 1,024 x 800 pixels. If the display resolution of the input signal is different from the native resolution, image compression or expansion will be used to convert the input signal to a level within the native resolution.
Page 11
• It may not be possible to send or receive commands for about 10 to 60 seconds when the lamp is first turned on. If this occurs, wait for 60 seconds, then try sending or receiving again. • When sending multiple commands, be sure to wait for at least 0.5 second after receiving a response from the projector before sending the next command.
Page 12
* Do not send PON, POF, OSH, or OLP commands continuously in a short period of time. Doing so may burst the lamp or shorten the lamp replacement cycle. * When a command that cannot be executed during standby mode is sent, the projector will send an ER401 command in reply. As of February 2009...
Page 13
PT-DW6300S/DW6300K/DW6300LS/DW6300LK ™ Projectors Status asking commands Command : Parameter Function Main power status Shutter function status Freeze function status Input signal status On-screen display status Projector run time Q$L:1 Lamp 1 run time Q$L:2 Lamp 2 run time Lamp operation mode status...
Page 14
* Even when the ambient temperature near the intake opening is 40°C/104°F or lower, an accumulation of hot air inside the cabinet may cause the protective circuit to activate and shut down the projector. Please give ample consideration to the design with regard to ambient temperature conditions.