Microphone Bracket Installation - Motorola APX6000 User Manual

3. When the bracket is mounted in carpet, the self-tapping screws tend
to bind up. To overcome this, tap the screw through the carpet, back
out the screw, then tighten the screw down.
1. Use the console to trunnion screws from the kit packaging (unit box).
2. Ensure that the plastic guides of the trunnion are aligned (horizontally)
with the corresponding grooves of the console (see Figure 2). Slide the
APX VA console into the plastic guides until it reaches the mechanical
stop. Verify that the holes in the trunnion bracket are aligned with the
holes on the APX VA.
3. Insert the Allen-screws provided through the trunnion bracket and screw
them into the console. Since the console may have to be removed later to
connect the cables, do not tighten the screws at this time.

Microphone Bracket Installation

Note: The microphone bracket should be mounted on a substantial structure.
Otherwise, repeated insertion and removal of the microphone could
loosen it. Referring to Figure 3, use the microphone bracket as a
template and drill two 1/8-inch (0.32cm) holes. Attach the microphone
bracket to the mounting surface with the two self-tapping screws
provided. Be sure to leave sufficient room above the bracket for
inserting and removing the microphone.
16
Figure 1: Console Installation Detail
M5 x 18mm Mounting
Bracket Hardware
Note: Use only the M5 x 18mm
screws supplied with the unit.