Troubleshooting - D-Link AirPlus DI-614+ Manual

Troubleshooting

This chapter provides solutions to problems that can occur during the installation and
operation of the DI-614+ Wireless Access Point. We cover various aspects of the
network setup, including the network adapters. Please read the following if you are
having problems.
(Note: It is recommended that you use an Ethernet connection to
1. The computer used to configure the DI-614+ cannot access the
Configuration menu.
Note: The IP Address of the DI-614+ is 192.168.0.1. All the computers on the
network must have a unique IP Address in the same range, e.g., 192.168.0.x. and
a Subnet Mask of 255.255.255.0. Any computers that have identical IP Addresses
will not be visible on the network.
configure the DI-614+ Access Point.)
Check that the Ethernet LED on the DI-614+ is ON. If the LED is
not ON, check that the cable for the Ethernet connection is securely
inserted.
Check that the Ethernet Adapter is working properly. Please see
item 6 (Check that the drivers for the network adapters are
installed properly) in this Troubleshooting section to check that
the drivers are loaded properly.
Check that the IP Address is in the same range and subnet as the
DI-614+. Please see Checking the IP Address in Windows XP in
the Networking Basics section of this manual.
Do a Ping test to make sure that the DI-614+ is responding. Go to
Start>Run>Type Command>Type ping 192.168.0.1. A successful
ping will show four replies.
50