Image Display Method - Panasonic AW-PB309P Operating Instructions Manual

Image display method

Start up the browser, and input the address.
http://(new IP address setting)/user/pb309.html
Images can be displayed when the following address is input in the factory setting status.
http://192.168.1.50/user/pb309.html
When this address is input, an image such as the
one shown in Fig. 1 appears. (The image is a
sample.)
HIGH is set for the image quality and VGA (640
a 480) is set for the size in the initial status.
To change the image quality or size, click the
button under the image.
Image Control
When this button is clicked, the window shown in
Fig. 2 is opened. Now change the setting or
settings.
QUALITY and SIZE on the Image Control window
function as follows.
1) QUALITY
HIGH : JPEG compression rate of approximately
one-sixth
MID : JPEG compression rate of approximately
one-ninth
LOW : JPEG compression rate of approximately
one-fifteenth
These compression rates differ from one subject
to another and thus serve merely as guidelines.
2) SIZE
VGA : JPEG compression using 640 a 480
pixels
HVGA : JPEG compression using 640 a 240
pixels
QVGA : JPEG compression using 320 a 240
pixels
In the HVGA mode, JPEG compression is implemented in 1-field increments, and images are enlarged
to twice their original size in the vertical direction and displayed by the browser. This mode is best
suited to subjects which move a lot.
The quality and size in which the image is to appear when the power is turned on can be set on the
Config screen. (See pages 12 and 13)
<Note>
If the "Image Display" and "Image Control" windows are open and these windows are to be exited,
close each window.
(The "Image Control" window will not be automatically exited when the "Image Display" is closed.)
9
Fig. 1
Fig. 2