S-Vhs Quasi Playback (Sqpb); To Play Back A Recorded Part Repeatedly; Vhs Index Search System (Viss); Adjusting The Playback Picture - Panasonic DIGA DMR-E75V Operating Instructions Manual

Playback
DVD/VHS
DIRECT TV REC
Numeric
Buttons
CANCEL/RESET
:, 9
∫
DIRECT NAVIGATOR
TOP MENU
ENTER
SUB MENU
PROG/CHECK
µ
REC MODE
EXT LINK
EXT LINK
Preparation
≥Press [VHS].
≥Insert a recorded video cassette.

S-VHS Quasi Playback (SQPB)

It is also possible to play back tapes recorded in the S-VHS system.
≥Some picture noise may occur depending on the type of tape used.
≥It is not possible to fully obtain the high resolution that S-VHS is
capable of.
≥It is not possible to record in the S-VHS system with this unit.

To Play back a Recorded Part Repeatedly

During play or while stopped
Keep pressing [1, PLAY] for 5 or more
seconds.
≥The "RP" indication appears on the display.
∫ To cancel the Recorded Part Repeatedly
Press [∫, STOP].

VHS Index Search System (VISS)

This unit automatically records special index signals on the tape
every time a recording is started. The Index search function makes
use of these index signals to let you find the beginning of a desired
programme quickly and easily.
While stopped or during normal play
: 9
Press [ ] or [
≥The unit automatically starts playback after the
index signal is found.
≥Each press increases the number of skip.
∫ To cancel the Index Search or to stop playback
Press [∫, STOP].
52
VOLUME
CH
AV
VHS
DVD/VHS
VHS DVD
DVD
TRACKING/V-LOCK
TRACKING/
V-LOCK, i, j
CH, W, X
G-Code
CREATE CREATE
INPUT SELECT
CHAPTER CHAPTER
SLOW/
SKIP/INDEX REW SEARCH FF
STOP PAUSE PLAY
1
;
FUNCTIONS
ENTER
RETURN
STATUS
DISPLAY STATUS TIME SLIP
JET REW
VHS REC REC MODE DVD REC TIMER
AUDIO
DUBBING
VHS DVD
].
Note
≥Up to 20 index signals can be searched for in both directions.
≥When you press either one of the button too much, you can control
the number of skips by pressing the opposite button.
≥The figure on the display decreases by 1 each time an index signal
is located.
≥This feature may not work correctly if the marks are too close
together. Make recordings of at least 5 minutes.

Adjusting the playback picture

∫ Manual tracking

The unit automatically makes tracking adjustments, but you may
need to do it manually, if noise appears on a tape recorded on other
equipment.
During normal or slow playback,
Press [TRACKING/V-LOCK, i, j] until the bars
noise disappear.
≥If the noise bars appear during still playback, switch the VHS over
to the slow playback mode and then adjust the tracking.
∫ To return to auto tracking
Press both [TRACKING/V-LOCK, i, j] i and j simultaneously.

∫ Vertical locking adjustment

If the still picture shakes, perform the following operation.
During still playback,
Keep [TRACKING/V-LOCK, i, j] pressed until the
picture stops shaking.
∫ To return to auto tracking
Press both [TRACKING/V-LOCK, i, j] i and j simultaneously.
∫ To remove the noise from a paused picture
Start slow play, then adjust the tracking.
Note
≥This may not work with some TV models and tapes.

To Play back a tape in high picture quality

You can play back a tape in Progressive video or RGB video with TP
channel.
Preparation
Connect this unit and the TV and then set the output.
≥RGB Output l 9, 45
≥Progressive l 14, 45
[1]
Press [DVD].
[2] Press [CH, W, X] to select the "TP" channel.
≥About TP channel l 59
[3]
Press [VHS] and then press [1, PLAY].
≥The tape starts playing back in high picture quality.
Note
≥Check if the setting on "TV Aspect" is suited to the size of your TV.
("SETUP"-"Connection"-"TV Aspect", l 45)
≥The TV must be RGB-compliant or Progressive-compliant.
VHS