Connection With The Monitors; Connection With The Wv-Cu360 System Controller - Panasonic WJ-FS316 Operating Instructions Manual

Connection with the Monitors

Connect the Monitors to the Spot Output (SPOT OUT)
Connector and Multiscreen (MULTISCREEN OUT) Output
Connector on the rear of the Video Multiplexer.
MULTI
SCREEN OUT
Video Monitor
Connection with the WV-CU360
System Controller
Basic Connection
Connect the DATA jack on the Video Multiplexer to
the DATA OUT jack on the System Controller with the sup-
plied RS-485 cable (part of standard accessories of the
System Controller).
Video Multiplexer
WJ-FS309/FS409/
FS316/FS416
DATA
RS-485 Cable
Loop-through Connection
1. Plug the branch cable (optional accessory) into the
DATA jack of the Video Multiplexer.
2. Connect one end of the branch cable to the DATA OUT
jack on the System Controller with the supplied RS-485
cable.
Video Multiplexer
WJ-FS309/FS409/
FS316/FS416
DATA
Branch Cable
26
SPOT OUT
Video Monitor
System Controller
WV-CU360
DATA
System Controller
WV-CU360
DATA
RS-485 Cable
If the cable is locally procured, make sure it is data
grade cable suitable for RS-485 communication. A 2-
wire twisted pair shielded cable, BELDEN 9406 or
equivalent should be used. Pin assignments and data
flow are shown below.
No. Name
GND
1
1
RX(B) WJ-FS309/FS316/FS409/FS416 WV-CU360
2
3 RX(A) WJ-FS309/FS316/FS409/FS416 WV-CU360
4 TX(B) WJ-FS309/FS316/FS409/FS416 WV-CU360
TX(A) WJ-FS309/FS316/FS409/FS416 WV-CU360
5
6
GND
6
Setting the System Controller
The setting is briefly described below. For further details
refer to the Operating Instructions for the WV-CU360
System Controller.
0
5
1 2
CONTROLLER No.
1. Rotate the CONTROLLER NO. switch to set the con-
troller number.
2. Set the 8-bit DIP switch to specify the communication
mode.
Termination for RS-485 chain
Termination is important for stable communications in the
RS-485 chain. It must be located at only one point at the
end positions in the chain.
• If a System Controller is at the end of the chain, set the
5th bit of the DIP switch to ON. See the illustration
above.
• If a Video Multiplexer is at the end of the chain, plug the
terminator (optional accessory) into one end of the
branch cable as shown below.
WJ-FS309/FS409/FS316/FS416
Branch Cable
Terminator RS-485 Cable
(If necessary)
Data Flow
No.
Controller
–
1
end
2
3
4
5
–
6
OFF
ON
3 4 5 6 7 8
MODE
WV-CU360
1
6