Pppoe - D-Link Wireless AC1200 User Manual

Section 3 - Configuration
Select PPPoE (Point-to-Point-Tunneling Protocol) if your Internet connection requires you to enter a username and password. This information can
be provided by your Internet service provider (ISP). Required fields will vary, depending on the options you have enabled.
PPPoE Session: Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
Username: If you selected Create a new session above, enter the PPPoE
Username provided by your ISP.
Password: If you selected Create a new session above, enter the PPPoE
Password provided by your ISP.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP Address provided by your ISP (for Static IP only).
Service Name: If you selected Create a new session above, enter the ISP Service
Name (optional).
Reconnect If you selected Create a new session above, select either Always
Mode: on, On demand, or Manual.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
DNS Type: Select either Obtain DNS server address or Use the following DNS .
Primary DNS If you selected Use the following DNS, enter the Primary DNS
Server: Server address.
Secondary DNS If you selected Use the following DNS, enter the Secondary DNS
Server: Server address.
D-Link DIR-850L User Manual

PPPoE

43